Model Simulasi Implementasi Algoritma Perturb & Observe MPPT Pada Modul PV Menggunakan Matlab-Simulink
Kata Kunci:
PV, Buck Converter, MPPT, P&O, Matlab SimulinkAbstrak
This paper presents a simulation model procedure for the implementation of the Maximum Power Point Tracking Algorithm - MPPT (Maximum Power Point Tracker) "Perturb & Observe (P&O) on the Photovoltaic (PV) Module using Matlab-Simulink programming. In detail, it explains the integration of the PV module model series, the Buck DC-DC converter with MPPT completeness using the P&O algorithm method. Modeling is done using the Matlab-Simulink programming. The simulation results show a valid MPPT response in determining the power operating point (duty cycle of the DC-DC converter) for various levels of sunlight irradiation and solar cell temperature.
Referensi
C. Hua, J. Lin, and C. Shen, “Implementation of a DSP- controlled photovoltaic sistem with peak power tracking”, IEEE Trans. Industrial Electronics, vol. 45, pp. 99-107,Feb. 2008.
M.G. Villalva, J.R. Gazoli and E.R. Filho, “Modeling and Circuit-based Simulation of Photovoltaic Arrays”, IEEE Trans. Power Electronics, vol. 25, pp. 1198-1208, 2009.
J.H. Jung, and S. Ahmed, “Model Construction of Single
Crystalline Photovoltaic Panels for Real-time Simulation,”
IEEE Energy Conversion Congress & Expo,September 2010, USA.
Z. Salameh, F. Dagher, and W.A. Lynch, “Step-Down Maximum Power Point Tracker for Photovoltaic Sistem,” Solar Energy, vol. 46, No. 1, pp. 278-282, 1991.
A. Oi, “Design and Simulation of Photovoltaic Water Pumping
Sistem,” in Electrical Engineering, vol. Master of Science in
Electrical Engineering, California Polytechnic State University, pp. 113, 2005.
